Mount the sensor 3 at the appropri- ate position so that the center of the magnet 5 will align with the marked line on the sensor when the wheel is rotated. Secure the sensor 3 with the larger nylon ties 7 at the appropriate place and in the right direction.ĥ on a spoke of the front wheel so that the surface of the magnet will face the sensor. Mount sensor and adjust the gap between the magnet and the sensor. Please don’t throw away this manual, Keep the manual at a place easily accessible. Please read these instructions carefully before attempting to install and use your CAT EYE ENDURO 8 computer so that you understand the functions of this product. The position of the magnet and the sensor.ġ Bracket 2 Cord 3 Sensor 4 Sensor Rubber Padĥ Magnet 6 Bracket Rubber Pad 7 Five Nylon Ties 8 Spiral Tube When the computer does not indicate the speed, check Rotate the front wheel gently and see if the computer indicates the running speed. Turn the handlebar from left to right without pulling the wire. When you need to detach the computer, slide forward the computer with the lever pushed simultaneously.Īllow enough wire clearance in the area marked with an The contact points are automatically closed. Slide the computer into the bracket 1 until you hear the click sound. Put the rubber pad 6 on the bracket 1 and secure the bracket on the handle bar with the screw. Secure the cord on the fork with the nylon ties 7 and lead to the handle bar along the outer cable of the bicycle by means of the spiral tube 8. The computer is combined with the following parts. Installation of the Computer on Your Bike Tire size is usually shown on the sidewall of tires. You need to know the tire circumference (L cm) be- forehand. When you want to start the odometer from zero,.Used odometer, keep pressing the MODE button for two seconds and input the reading. When you want to input the reading of the currently.Select the measurement unit, kilometer or mile, by pushing the MODE button. (the screen will show the time measurement in this state) Setting is completed by pushing the SET button. You can easily set it by referring to the chart shown (the odometer starts from the reading you inputted) Stable measurement when you use this system for the first time and every time the battery is replaced. Push three buttons (MODE, START/ STOP and SET) at the same time. (For 1st use or after replacing the battery) Don’t use thinner, benzene or alcohol to wipe the surface of theĬomputer.Avoid unnecessary prolonged exposure to the sun.Keep batteries out of reach of small children.Periodically check to insure they are mounted securely and the screws are not loosen. Be sure to securely mount the magnet, the sensor, and theīracket on your bicycle.Pay attention to the road or trail! Do not be distracted by the.
0 Comments
Leave a Reply. |